Shanghai Chenjie Printing Material Co., LTD
Model No.: 001
Dosage Concentration Ratio: 1-3%
Specification: 18 L/barrel, 20 L/barrel
Packaging: 18 l/barrel, 20 l/barrel
Place of Origin: Shanghai
Supply Ability: 10000000000kg
HS Code: 3402900090
Port: Shanghai Outer Harbour,Shanghai Yangshan Port,Wusong Port
1. This product has a strong function of cleaning UV ink, non-toxic, odorless, non-flammable, storage security
2. No adverse effects and damage to the ink roller and Ps Plate
3. Concentrated ink cleaning agent cleaning printing machine Compared with gasoline, the same cleaning time and cleaning effect, cost-cost ratio
Gasoline low! And safer!
Printing UV Blanket And Roller Wash ink cleaner How to use and technical instructions:
1. Put a proper amount of ink Roller Cleaner in a small plastic bottle. Drill a small hole with a diameter of 0.5 mm on the bottle cap.
2. Check if the scraper is in good condition. If it is damaged, it should be replaced.
3. Check if the ink roller is horizontal and it should be replaced if it is too old (otherwise the amount of cleaning agent will increase during the cleaning process)
· 4. Check whether the rotating roller, PS plate, and ink roller are completely separated, Separate cleaning can wash quickly and clean.
· 5. Before starting the machine, spray the cleaner on the ink fountain and the rotating roller. After the ink roller is washed, scrub the ink fountain and turn the roller.
Turn on the machine (up to the highest speed) and then sprinkle the proper amount of ink cleaner on the ink roller and spray it back and forth 2-3 times.
The interval between showers is 15-20 seconds (large machine time is longer). Wait 1-2 minutes after operation
Tighten the ink (this should be paid special attention).
6. After tightening the ink scraper, the connection between the ink scraper and the ink roller is good, and the ink on the ink roller is completely scraped off after about 1 minute.
If the ink roller is not clean, you should continue to add the appropriate amount of ink cleaner to the ink roller until it is clean.
7. The rubber roller is cleaned. After the water is flushed on the roller, the ink scrapes off the milky white liquid. After the flushing continues until the scraper is clean, it can be stopped. The entire cleaning process takes 4-5 minutes.
Copyright © 2020 Shanghai Chenjie Printing Material Co., LTD All rights reserved.